Skip to main content

HIAD Causes: Material/Manufacturing Error


A hydrogen generator overheated during testing and started a small fire in a power plant.
A fire on one of the two hydrogen units at a gasoline refinery, hindering production.
The incident occurred when delivering liquid hydrogen to a stationary storage system of a semiconductor plant. Cold gaseous hydrogen was vented for unknown reason, ignited and created a plume of…
A fire developed on a tube trailer transporting 330 kg of compressed hydrogen, while travelling on a highway. The truck had left a plant of hydrogen production and storage to deliver to a refuelling…
A weld on a 1 inch diameter instrument tapping from a Octafiner reactor overhead line fractured, resulting in a small but intense fire, lasting about 50 minutes until the unit was nitrogen purged.…
A LH2 trailer was delivering at a customer’s site. Just after having terminated the transfer to the stationary tank approximately 13000 gallons (3500 kg) of liquid hydrogen, the pressure relief valve…

A fire in a first stage 'pygas' (pyrolysis of gasoline) hydrogenation of a naphtha cracker was caused by escape of a mixture of gasoline, hydrogen and nickel catalyst through a crack in…

A truck-trailer transporting 4,000 pounds of compressed hydrogen burned to ground, including the driver cabin. The driver was able to get out before it got fully engulfed. 3- to 4-feet of flames were…

A truck carrying cylinders was travelling on a highway when its front tyre burst. It rolled over in a farm and the gas started leaking from the cylinders. The driver called the emergency service.…

A truck driver carrying compressed gas cylinders loaded on pallets stopped on the emergency stop lane of a highway after a tyre burst. The gases transported were: 120 m³ of oxygen, 24 acetylene…

At a chemical processing plant, a release of pressurised hydrogen gas resulted in an explosion and fire injuring lightly three workers and causing damage to plant. The incident occurred during the…

While a LH2 barge was being disconnected from dock, a flash occurred in the vent stack. No damage occurred but potential existed for major damage. [Ordin, NASA (1974)]

A liquid hydrogen tanker was returning empty to the home terminal after delivery to a customer. At a stop, the drivers executed a visual inspection of the vehicle and noticed an accumulation of…

A gas leak containing hydrogen and hydrogen sulphide (H2S) occurred at the upper isolation valve located at a high-pressure separator (300 bar). This unit spearates the process gases from process…

The incident occurred while transferring gaseous hydrogen from a tube trailer to a customer stationary supply system. The transfer hose ruptured and released hydrogen which ignited explosively.…

The leak ignited at the seal located between the bottom and the body of a heat exchanger of a desulphurization unit of a refinery. The fire is alimented by the leaking fuel under pressure for about…

The incident occurred at a reactor vessel of a naphtha hydrotreater unit. The vessel operated at around 25 bar and 140 C. A 1. 5-meter crack opened up in the reactor vessel close to welded vessel…

An explosion and fire occurred at a reciprocating recycle hydrogen compressor during commissioning of a new Diesel hydrotreatement Unit. It happened during the reactor pre-sulphidisation step, when…

This incident occurred at a hydrogen refuelling station with on-site hydrogen production based on reforming of city gas and natural gas. The part affected was a coil in the heat exchanger…

The event occurred in the continuous casting of hot metallic melt of the plant. Cooling water leaked through a crack in the cooling water inlet pipe of a secondary cooling line and directly into the…